1.6 TDI CR engine (EA189) · Mixture preparation – injection · High-pressure pump

Removing and installing high-pressure pump

To prevent the high-pressure fuel pump from running while it is empty (very tight tolerances) and to ensure that the engine starts quickly after parts have been renewed, it is important to observe the following:

  • If the high-pressure pump is removed or renewed, the fuel system must be bled before engine is started for the first time.

Initial fuel filling procedure ⇒ 1.3 Filling/bleeding fuel system.

Removing and installing high-pressure pump: drawing 1

Special tools and workshop equipment required

  • Counter-hold tool - T10051-
  • Puller - T40064-
  • Thrust piece - T40064/1-
  • Torque wrench - V.A.G 1331-
Removing and installing high-pressure pump: drawing 2
  • Pliers - 3314-

Removing

Removing and installing high-pressure pump: drawing 3
  • Position pliers - 3314- with groove -arrow A- on support sleeve shoulder -arrow B- and pull plugs off glow pin plugs.
Removing and installing high-pressure pump: drawing 4
  • Carefully pull connector off glow plug in direction of -arrow-.
Removing and installing high-pressure pump: drawing 5
  • Separate connector -1- from fuel temperature sender - G81-.

Polo

Removing and installing high-pressure pump: drawing 6
  • Unclip coolant return hose -arrows- and place coolant line to one side.

2) There are different installation positions for the coolant return hose.

Continued for all vehicles

Removing and installing high-pressure pump: drawing 7
  • Pull fuel supply line -arrow- off the high-pressure pump.
Removing and installing high-pressure pump: drawing 8
  • Unscrew -1, 3, 4-. Separate connector -arrow- from fuel metering valve - N290-.
Removing and installing high-pressure pump: drawing 9
  • Unscrew bolts -4- and then remove bracket.
Removing and installing high-pressure pump: drawing 10
  • Pull off fuel return line -2-.
Removing and installing high-pressure pump: drawing 11
Removing and installing high-pressure pump: drawing 12
  • Counterhold hub of high-pressure pump using counterhold - T10051- and unscrew securing nut -1-.
Removing and installing high-pressure pump: drawing 13
  • Apply puller - T40064- with thrust piece - T40064/1- and pin - T40064/2- as shown in illustration and pull hub off high-pressure pump. If necessary, counterhold with a 24 mm open-end spanner.
Removing and installing high-pressure pump: drawing 14
  • Unscrew securing bolts -arrows- for high-pressure pump.
  • Remove high-pressure pump.

Installing

Install in reverse order. Specified torques for fuel system ⇒ 1.2.1 Assembly overview - fuel system, Polo

Specified torque for toothed belt drive, Polo ⇒ 2.1.2 Assembly overview - toothed belt, Polo

Removing and installing high-pressure pump: drawing 15

Specified torques -1, 3, 4-

In illustration 1 = 8 Nm

In illustration 3 = 8 Nm

In illustration 4 = 20 Nm

  • Connect vehicle diagnostic tester.
  • Read event memory and erase stored event entry if necessary.
  • Filling/bleeding high-pressure pump/fuel system ⇒ 1.3 Filling/bleeding fuel system.
  • Perform the function “Resetting engine control unit programmed values” in “Guided functions”.

Tightening torques on this page

3 torques

In the steps

StepTorque
In illustration 1 = 8 Nm8 Nm
In illustration 3 = 8 Nm8 Nm
In illustration 4 = 20 Nm20 Nm

All tightening torques in this manual →