1.6 TDI CR engine (EA189) · Mixture preparation – injection · Senders and sensors
Removing and installing fuel pressure regulating valve N 276
Special tools and workshop equipment required
- Torque wrench
- Open jaw insert, 36 mm AF
Fuel pressure regulating valve - N 276- -6- is located on fuel rail.

It ensures pressure is constant in fuel rail and in injector lines.
If pressure is too high in the fuel high-pressure circuit, fuel pressure regulating valve - N 276- opens.
As a result a small amount of fuel from the fuel rail will make its way back to fuel tank via the return line.
If pressure is too low in fuel high-pressure circuit, fuel pressure regulating valve - N 276- closes.
This seals the high-pressure side against the low-pressure side.
Removing
- Remove engine cover panel ⇒ 3 Engine cover panel.
- Removing high-pressure accumulator ⇒ 3.6 Removing and installing fuel rail.
- Clean threaded area around fuel pressure regulating valve - N 276- (e.g. with standard cleaning solution) before removing.
Under no circumstances may dirt enter the hole on the fuel rail element (fuel rail).
- Dry fuel pressure regulating valve - N 276-.
- Loosen regulating valve using 36 mm open-end spanner insert. Then unscrew and remove by hand.
- Extract dirt from threads and sealing surfaces. Do not use tools or other instruments for this purpose.
Installing
- Screw in fuel pressure regulating valve - N 276- by hand.
- To tighten union nut, use a suitable torque wrench with a 36 mm open-end spanner insert.
- Install fuel rail ⇒ 3.6 Removing and installing fuel rail.
- Specified torque: ⇒ 1.2 Assembly overview - fuel system
- Check fuel system for leaks.
- Connect vehicle diagnostic tester.
- Read event memory and erase stored event entry if necessary.
- After installation, run engine at moderate speed for several minutes and then switch off.
- Then test drive the vehicle, accelerating to full throttle at least once.
- Then check high-pressure part of fuel system again for leakage.
- Read event memory again.