1.6 TDI CR engine (EA189) · Mixture preparation – injection · Air filter

Air filter housing – assembly overview and fastening

⇒ 7.1.2 Assembly overview - air filter housing, Polo

7.1.2 Assembly overview - air filter housing, Polo

Assembly overview – air filter housing: drawing 1
  • 1 Bolt
    • 2 Nm
  • 2 Air mass meter - G70-
  • 3 Flow conditioner
  • 4 O-ring
    • Renew if damaged
  • 5 Bolt
    • 2 Nm
  • 6 Air filter upper part
  • 7 Bolt
    • 8 Nm
  • 8 Hot air intake B
    • Depending on equipment
  • 9 Grommet
  • 10 Bolt
    • 2 Nm
  • 11 Air filter lower part
  • 12 Rubber mounting
    • Renew if damaged
  • 13 Intake connecting pipe
    • Bolted to lock carrier.
  • 14 Air intake hose
    • Intake connecting pipe
  • 15 Water drainage pipe
    • Observe installation position
  • 16 Intake connecting pipe
    • With captive bolt, 9 Nm
  • 17 Spring-type clip
  • 18 Rubber mounting
    • Renew if damaged
  • 19 Filter element
    • To remove, turn 1/4 turns anti-clockwise
  • 20 Suction hose
    • To turbocharger
    • With heater for crankcase breather system for vehicles in cold climate zones
  • 21 Spring-type clip
  • 22 Connecting pipe
    • From cylinder head cover
    • For crankcase breather
  • 23 Hose
    • For hot air intake.
    • Depending on equipment

Tightening torques on this page

5 torques

7.1.2 Assembly overview - air filter housing, PoloTo the drawing ↑

Drawing with the item numbers: 7.1.2 Assembly overview - air filter housing, Polo
ItemPartTorqueNotes
1Bolt2 Nm
5Bolt2 Nm
7Bolt8 Nm
10Bolt2 Nm
16Intake connecting pipe9 NmWith captive bolt

All tightening torques in this manual →