1.6 TDI CR engine (EA189) · Mixture preparation – injection · Injection system
Schematic overview – fuel system
⇒ 1.1.1 Schematic overview - fuel system, Polo
1.1.1 Schematic overview - fuel system, Polo
To prevent the high-pressure fuel pump from running while it is empty and to ensure that the engine starts quickly after parts have been renewed, it is important to observe the following:
- If fuel system components between fuel tank and fuel highpressure pump are removed or renewed;
- If a fuel system pressurisation pump - G 6 -, fuel line or fuel filter is removed or renewed
- If the fuel high-pressure pump is removed or replaced
- Connect vehicle diagnostic tester.
- Perform the function “Fuel pump activation (Filling/bleeding fuel system)” in “Guided Functions” ⇒ 1.3 Filling/bleeding fuel system.
- 1 Fuel metering valve - N290-
- Do not open.
- 2 High-pressure pump
- After renewing, a first fuel filling “must” be performed (never allow pump to run while dry) ⇒ 1.3 Filling/bleeding fuel system.
- Removing and installing ⇒ 4.2 Removing and installing high-pressure pump
- 3 Fuel pressure sender - G 247-
- Installing and removing ⇒ 5.3 Removing and installing fuel pressure sender - G 247-
- 4 High-pressure accumulator
- 5 Fuel pressure regulating valve - N 276-
- Renew
- Checking ⇒ 5.2 Checking fuel pressure regulating valve - N276-
- Removing and installing ⇒ 5.1 Removing and installing fuel pressure regulating valve - N 276-
- 80 Nm
- 6 Injectors
- Injector, cylinder 1 - N30-
- Injector, cylinder 2 - N31-
- Injector, cylinder 3 - N32-
- Injector, cylinder 4 - N33-
- Installing and removing ⇒ 3.5 Removing and installing injectors
- 7 Fuel return lines
- The fuel return lines must not be dismantled. They can only be renewed together with the pressure retention valve as one unit.
- After renewal, engine must be run at idling speed for approx. 2 minutes to bleed fuel system. Then check fuel return lines for leaks.
- 8 Pressure retention valve
- The non-return valve has the task of maintaining a residual pressure (control volume) of approx. 1 bar in the fuel return lines.
- This residual pressure is required for the control function of the piezo injectors.
- The pressure retention valve may only be renewed completely together with the fuel return lines.
- Fitting location: within fuel return lines, just before metal return line
- After replacement, engine must be run at idling speed for approx. 2 minutes to bleed fuel system.
- Check pressure retention valve ⇒ 3.4 Check pressure retention valve in fuel return line.
- 9 Fuel
- With fuel pump - G6-
- 10 Fuel preheater valve
- 11 Fuel filter
- Assembly overview ⇒ Rep. gr. 20; Fuel filter; Assembly overview - fuel filter
- Removing and installing fuel filter ⇒ Rep. gr. 20; Fuel filter; Removing and installing fuel filter.
Tightening torques on this page
1 torque
1.1.1 Schematic overview - fuel system, PoloTo the drawing ↑
