1.6 TDI CR engine (EA189) · Mixture preparation – injection · Injectors/high-pressure accumulator (rail)

Injectors – assembly overview and fastening

Assembly overview – injectors: drawing 1
  • 1 Injectors
    • If they are to be reinstalled, the injectors, highpressure lines and clamping pieces must only ever be refitted on the same cylinder.
    • Before installing, clean injector bore using cleaning set - VAS 6811-
  • 2 Bolt for clamp
    • Renew

Tighten securing bolts to a maximum of 1 to 2 Nm at first.

After the high-pressure lines have been fitted. Final specified torque: 8 Nm + turn 270° further.

  • 3 High-pressure fitting
    • Counterhold when loosening the high-pressure lines
  • 4 Return lines retaining clip
    • Do not reuse, renew
    • Grease the retaining clip lightly before installing the injector.
  • 5 Copper washer
    • Renew
  • 6 O-ring
    • Renew

Tightening torques on this page

2 torques

In the steps

StepTorque
Tighten securing bolts to a maximum of 1 to 2 Nm at first.2 Nm
After the high-pressure lines have been fitted. Final specified torque: 8 Nm + turn 270° further.8 Nm

All tightening torques in this manual →