1.6 TDI CR engine (EA189) · Mixture preparation – injection · Senders and sensors

Removing and installing fuel pressure sender G 247

The fuel pressure sender - G 247- is located in the fuel rail, measures the current fuel pressure in the high-pressure system and transmits a voltage signal to the diesel direct injection system control unit - J248-.

If the sender fails, the pressure is regulated by the engine control unit using a map. In back-up function, the maximum engine speed is limited to approx. 3,000 rpm.

Removing

Follow these instructions before starting work and while working on the fuel system.

  • Remove engine cover panel ⇒ 3 Engine cover panel.
  • Before removal, clean area around thread for fuel pressure sender, using e.g. a cold cleaning solvent. No dirt must enter the bore in the fuel rail.
  • Dry fuel pressure sender - G 247-.
  • Pull electrical connector off fuel pressure sender - G 247-.
  • Unscrew fuel pressure sender - G 247-.
  • Use suction device to extract dirt from high-pressure accumulator bore (threads and sealing surface). Do not use tools or other instruments for this purpose.

Installing

  • Screw in fuel pressure sender - G 247- by hand.
  • Tighten sender. Specified torque ⇒ Item 13 (1.2.1 Assembly overview - fuel system, Polo).
  • After installation, run engine at moderate speed for several minutes and then switch off.
  • Check fuel system for leaks.
  • Read event memory.
  • Then test drive the vehicle with at least one full acceleration. Check high pressure part of fuel system again for leaks.
  • Read event memory.