1.6 TDI CR engine (EA189) · Mixture preparation – injection · Engine control unit

Removing and installing engine control unit

⇒ 9.1.5 Removing and installing engine control unit J623, Polo

⇒ 9.1.6 Removing and installing engine control unit J623 with protective housing, Polo

9.1.5 Removing and installing engine control unit - J623-, Polo

If you wish to renew the engine control unit, connect the vehicle diagnostic tester and perform the guided function “Renewing control unit”.

  • Switch off ignition.
Removing and installing engine control unit: drawing 1

Removing

  • Switch off ignition.
  • Release connectors on engine control unit and pull off connector.
Removing and installing engine control unit: drawing 2
  • Press clips -arrows A- outwards and pull engine control unit out to side -B-.

Installing

  • Insert new engine control unit and press to the left.
  • Fit connectors and lock in position.
  • Read event memory, rectify any faults and then clear event memory ⇒ Vehicle diagnostic tester “Guided fault finding”.
  • The readiness code must be generated if the event memory has been cleared.
  • Perform road test.
  • Read control unit event memory again.

9.1.6 Removing and installing engine control unit - J623- with protective housing, Polo

If you wish to renew the engine control unit, connect the vehicle diagnostic tester and perform the guided function “Renewing control unit”.

  • Switch off ignition.

Removing

Removing and installing engine control unit: drawing 3
  • Open wiring guide -1- and lift locking device -2-.
  • Take engine control unit out of retainer.
Removing and installing engine control unit: drawing 4
  • Unscrew shear-head bolt -1- using pliers.
  • Turn engine control unit -2- over and also unscrew all other shear-head bolts using pliers.
Removing and installing engine control unit: drawing 5
  • Pull retainer -1- and protective housing -2- off engine control unit -3- in -direction of arrow-.
  • Release connectors on engine control unit and pull off connector.

Installing

  • Fit connectors and lock in position.
  • Push the protective housing over the engine control unit.
  • Install retainer for protective housing using new shear-head bolts.
  • Tighten shear-head bolts evenly until heads shear off.
Removing and installing engine control unit: drawing 3
  • Insert engine control unit into mounting bracket on bulkhead until it audibly engages in catches -1-.
  • Insert wiring into wiring guide -1- and close guide.
  • If engine control unit has been renewed, clear learnt values and adapt engine control unit Vehicle diagnostic tester “Guided function”.
  • Read event memory, rectify any faults and then clear Vehicle diagnostic tester event memory “Guided Fault Finding”.
  • The readiness code must be generated if the event memory has been cleared.
  • Perform road test.
  • Read control unit event memory again.