1.6 TDI CR engine (EA189) · Mixture preparation – injection · Intake manifold

Removing and installing throttle valve module J338

Removing

  • Remove engine cover panel ⇒ 3 Engine cover panel.
  • Remove noise insulation:

    Polo ⇒ General body repairs, exterior; Rep. gr. 50; Noise insulation; Assembly overview - noise insulation

Removing and installing throttle valve module J338: drawing 1
  • Loosen hose clamps -1- and -2- and remove air hose.
Removing and installing throttle valve module J338: drawing 2
  • Unscrew bolts -arrows-.
  • Free off coolant hose -3-.
  • Release hose clip -2-.
  • Disconnect electrical connector -1- on charge pressure sender - G31- and remove air pipe.
Removing and installing throttle valve module J338: drawing 3
  • Disconnect connector -2-.
  • Remove bolt -1- for dipstick guide tube.
  • Unscrew bolts -arrows- and remove throttle valve module - J338-.

Installing

Install in reverse order, noting the following: