1.6 TDI CR engine (EA189) · Mixture preparation – injection · Injectors/high-pressure accumulator (rail)

Testing jammed-open injectors

Special tools and workshop equipment required

Testing jammed-open injectors: drawing 1
  • Hand vacuum pump - VAS 6213-
Testing jammed-open injectors: drawing 2
  • Make an -adapter- from a return line.
  • Collect escaping fuel with a cleaning cloth.
  • Open cleaned return line connection of injector to be tested using a small screwdriver and long-nosed pliers.
Testing jammed-open injectors: drawing 3

Always renew clips.

Testing jammed-open injectors: drawing 4
  • Pull off return line in direction of arrow.
Testing jammed-open injectors: drawing 5
  • Undo fuel high-pressure line -2-. To do this, only undo union nuts on high-pressure accumulator -1-.
  • Connect clean, blown-out adapter to injector to be tested.
Testing jammed-open injectors: drawing 6
  • Use hand-operated vacuum pump - VAS 6213- to generate vacuum of approx. -500 mbar.

If injectors are OK, pressure remains constant for 30 seconds.

If injectors are defective, the pressure drops to 0 bar within 2 … 3 seconds.

Repeat check if necessary, observe pressure loss at hand-operated vacuum pump - VAS 6213-.