1.6 TDI CR engine (EA189) · Mixture preparation – injection · Air filter

Removing and installing air filter housing

⇒ 7.2.2 Removing and installing air filter housing, Polo

7.2.2 Removing and installing air filter housing, Polo

Removing

Removing and installing air filter housing: drawing 1
  • Release catches -arrows-, remove air duct -1-.
Removing and installing air filter housing: drawing 2
  • Unclip bracket -arrows- together with vacuum hoses from air filter housing.
Removing and installing air filter housing: drawing 3
  • Disconnect connector -3-.
  • Remove intake hose, loosening hose clip -2- to do so.
  • Remove air hose; loosening hose clip -1- to do so if there is one.
  • Unscrew bolt -4- and remove air filter housing.

Remove suction hose

Removing and installing air filter housing: drawing 4
  • Remove crankcase breather hose -3-.
  • Pull vacuum hose -2- off intake hose -1- and move to side. Unclip bracket.
  • Completely undo bolt -4- (make sure bolt is captive).
  • Swing intake union to the right and remove with suction hose -1-.

Install intake hose

Installation is carried out in the reverse order. When installing, note the following:

Removing and installing air filter housing: drawing 5
  • When mounting intake connecting pipe on turbocharger, it must be ensured that intake connecting pipe is correctly seated on the bolt of the turbocharger. -arrow-.

Installing

Install in reverse order.

When doing this, observe the following:

  • Check air intake hose for salt residue, dirt and leaves and, if necessary, clean.
  • Check air duct leading from lock carrier to air filter housing for dirt and leaves. Clean if necessary.

Continue installation in reverse order of removal.

Removing and installing air filter housing: drawing 6
  • Guide water drainage pipe -arrow- between gearbox and body.
Removing and installing air filter housing: drawing 7
  • Check under the wing to see whether the water drainage pipe has been installed correctly.