1.6 TDI CR engine (EA189) · Mixture preparation – injection · Injectors/high-pressure accumulator (rail)
Check pressure retention valve in fuel return line
The pressure retention valve has the task of maintaining a residual pressure (control volume) of approx. 1 bar in the return lines.
This residual pressure is required for the control function of the injectors.
Special tools and workshop equipment required

- Pressure gauge - VAS 6330-
- Adapter - VAS 6330/3-1-
- Adapter - VAS 6330/3-2-
- Remove engine cover panel ⇒ 3 Engine cover panel.
- Clean return line connection on cylinder 1 (e.g. with cold cleaner) before removing.
- Dry return line connection on No. 1 cylinder.
- Cover return line connection on No. 1 cylinder with a cleaning cloth.
- Pull return line connection off No. 1 cylinder; pull out release clip to do this.


- Install tester for fuel return system - 6330- with adapters -VAS 6330/3-1- and -VAS 6330/3-2- between return line connection on injector and return line.
- Start engine.
- Check pressure on pressure gauge.
- Specification: approx. 1.0 bar
If the value does not match the specification, fit a new pressure retention valve.
After any work on the fuel system
- Observe instructions for working on fuel system ⇒ 3.1 Rules for cleanliness.