1.6 TDI CR engine (EA189) · Exhaust system · Exhaust pipes and silencers

Silencers – assembly overview and fastening

⇒ 1.1.3 Assembly overview - silencers, Polo

⇒ 1.1.4 Separating exhaust system

1.1.3 Assembly overview - silencers, Polo

Assembly overview – silencers: drawing 1
  • 1 Exhaust pipe with silencer
    • Coupling point
    • Marked by indentation on exhaust pipe.
    • As standard, exhaust pipe and rear silencer are installed as a single component. For repairs, exhaust pipe and silencer are supplied with a clamp separately
    • Cut through separating point on connecting pipe at right angles using e.g. pneumatic sabre saw - V.A.G 1523A- (wear eye protection).
    • Position double repair clamp at side marks when installing.
    • Tighten bolts of repair double clamp evenly, specified torque: M8 = 25 Nm, M10 = 40 Nm
    • Before tightening, align cold exhaust system free of tension ⇒ 1.2.2 Aligning exhaust system free of stress, Polo
  • 2 Retaining ring
    • 23 Nm
    • Renew if damaged
  • 3 20 Nm
  • 4 Tunnel cross-piece

1.1.4 Separating exhaust system

Special tools and workshop equipment required

Assembly overview – silencers: drawing 2
  • Body saw e.g. -V.A.G 1523 A-
  • Or
Assembly overview – silencers: drawing 3
  • Chain-type pipe cutter - VAS 6254-
  • Safety glasses

Procedure

To separate exhaust pipe and silence, exhaust pipe is engineered with a separation point marked by indentations.

Assembly overview – silencers: drawing 4
  • Cut through exhaust pipe at right angles using body saw at separating point -arrow 1-.
  • Position double clamp -4- on side markings -arrow 2- and -arrow 3- when installing.
Assembly overview – silencers: drawing 5
  • Install double clamp so that bolt ends do not protrude beyond bottom of clamp.
  • Bolt connections point to the right.
  • Tighten bolt connections of double clamps evenly to 23 Nm.

Before tightening, align cold exhaust system free of stress ⇒ 1.2.2 Aligning exhaust system free of stress, Polo.

Tightening torques on this page

4 torques

1.1.3 Assembly overview - silencers, PoloTo the drawing ↑

Drawing with the item numbers: 1.1.3 Assembly overview - silencers, Polo
ItemPartTorqueNotes
1Exhaust pipe with silencer25 NmCoupling point · Marked by indentation on exhaust pipe. · As standard, exhaust pipe and rear silencer are installed as a single component. For repairs, exhaust pipe and silencer are supplied with a clamp separately · Cut through separating point on connecting pipe at right angles using e.g. pneumatic sabre saw - V.A.G 1523A- (wear eye protection). · Position double repair clamp at side marks when installing. · Tighten bolts of repair double clamp evenly, specified torque: M8 = , M10 = 40 Nm
2Retaining ring23 NmRenew if damaged
320 Nm

1.1.4 Separating exhaust systemTo the steps ↑

StepTorque
Tighten bolt connections of double clamps evenly to 23 Nm.23 Nm

All tightening torques in this manual →