1.6 TDI CR engine (EA189) · Crankshaft group · Cylinder block (pulley end)
Removing and installing bracket for ancillaries
Removing
- Remove high-pressure pump ⇒ 4.2 Removing and installing high-pressure pump.

- Remove alternator ⇒ Electrical system; Rep. gr. 27; Alternator; Removing and installing alternator.
Vehicles with air conditioning system
- Unbolt air conditioner compressor from ancillary bracket, then secure to lock carrier ⇒ Heating, air conditioning; Rep. gr. 87; Air conditioner compressor; Removing and installing air conditioner compressor.
Continued for all vehicles

- Remove idler pulleys -1- and -2- and unscrew bolt for toothed belt guard -arrow-.

- Unscrew bolts -6…1- and remove ancillaries bracket.
Installing
Specified torque: Engine bracket ⇒ 1.8 Removing and installing engine bracket.
Install in reverse order. During this procedure, observe the following:
- Note any fitted sleeves in ancillary bracket and renew missing ones if necessary.
- Renew all bolts to be tightened with torque angle.
- Tack engine bracket bolt before tightening bolts for ancillary bracket.

- Install bolts as follows:
- Bolts -1- and -2- M10 x 52.
- Bolts -3- and -4- M10 x 30.
- Bolts -5- and -6- M10 x 60.
- Lifting eye bolts -A- and -B- 20 Nm.
- Tighten bolts -1 to 6- in 4 stages in the sequence shown:
| Sta ge | Bolts | Specified torque/turning further angle |
|---|---|---|
| 1) | -1 … 6- | Screw in by hand as far as stop |
| 2) | -1 … 6- | 40 Nm |
| 3) | -3- and -4- | Turn 45° further |
| 4) | -1, 2, 5, 6- | Turn 90° further |
- Install high-pressure pump ⇒ 4 High-pressure pump, install toothed belt and adjust valve timing ⇒ 2.2 Removing and installing toothed belt.
- Install alternator ⇒ Electrical system; Rep. gr. 27; Alternator; Removing and installing alternator.
- Installing high-pressure pump ⇒ 4.2 Removing and installing high-pressure pump.
- Remove air conditioner compressor from lock carrier, then position on ancillary bracket and tighten ⇒ Heating, air conditioning; Rep. gr. 87; Air conditioner compressor; Removing and installing air conditioner compressor.
- Install alternator ⇒ Electrical system; Rep. gr. 27; Alternator; Removing and installing alternator.
- Filling/bleeding high-pressure pump/fuel system ⇒ 1.3 Filling/bleeding fuel system.
Tightening torques on this page
2 torques
In the steps
| Step | Torque |
|---|---|
| Lifting eye bolts -A- and -B- 20 Nm. | 20 Nm |
| Part | Torque |
|---|---|
| 2) | 40 Nm |