1.6 TDI CR engine (EA189) · Crankshaft group · Crankshaft

Measuring radial clearance of crankshaft

Special tools and workshop equipment required

  • Plastigage

Procedure

  • Remove bearing cap.
  • Remove bearing cap and clean bearing journal.
  • Place a length of Plastigage corresponding to the width of the bearing on the journal or into the bearing shells.
  • The Plastigage must lie in the middle of the bearing shell.
  • Fit bearing cap and tighten bolts to 65 Nm without turning further angle and without rotating crankshaft.
  • Remove bearing cap again.
  • Compare width of Plastigage with the measurement scale.

Radial clearance:

  • New: 0.03 to 0.08 mm
  • Wear limit: 0.17 mm.

Tightening torques on this page

1 torque

In the steps

StepTorque
Fit bearing cap and tighten bolts to 65 Nm without turning further angle and without rotating crankshaft.65 Nm

All tightening torques in this manual →