1.6 TDI CR engine (EA189) · Crankshaft group · Cylinder block, gearbox end

Removing and installing flywheel

Special tools and workshop equipment required

Removing and installing flywheel: drawing 1
  • Counter-hold tool - 3067-

Removing

  • Remove gearbox ⇒ Rep. gr. 34; Removing and installing gearbox; Removing gearbox.
  • Mark position of dual-mass flywheel in relation to engine.
Removing and installing flywheel: drawing 2
  • Rotate the dual-mass flywheel -A- so that the bolts -B- align centrally with the holes -arrows-.
  • When unscrewing bolts -B-, ensure that none of the bolt heads come into contact with the dual-mass flywheel -arrows-. The flywheel will otherwise be damaged when the bolts are unscrewed further.
Removing and installing flywheel: drawing 3
  • Insert counterhold - 3067- in hole on cylinder block -B-.
  • Unscrew dual-mass flywheel.

Installing

Installation is carried out in the reverse order. When installing, note the following:

  • Use new bolts for securing.
Removing and installing flywheel: drawing 4
  • Insert counter hold - 3067- in hole on cylinder block -A-.