1.6 TDI CR engine (EA189) · Crankshaft group · Cylinder block (pulley end)
Renewing crankshaft oil seal – belt pulley end

Special tools and workshop equipment required
- Seal puller - 3203-
- Counter-hold tool - 3415-
- Assembly tool - T10053-
- Torque wrench (5 … 50 Nm) - V.A.G 1331-
- Torque wrench (40 … 200 Nm) - V.A.G 1332-
Removing
- Remove toothed belt ⇒ 2.2 Removing and installing toothed belt.

- Remove crankshaft sprocket. To do this, lock toothed belt pulley using counterhold - 3415-.
- To guide oil seal extractor - 3203-, screw central bolt by hand into crankshaft to stop.
- Unscrew inner part of oil seal extractor 2 turns (approx. 3 mm) out of outer part and lock with knurled screw.
- Oil threaded head of oil seal extractor.

- Using great pressure, screw oil seal extractor as far as possible into seal.
- Loosen knurled screw and turn inner part against crankshaft until oil seal is pulled out.
Installing
- Remove oil residue from crankshaft journal using clean cloth.

- Place guide sleeve - T10053/1- onto crankshaft journal.
- Slide oil seal over guide sleeve onto crankshaft journal.

- Press oil seal in to stop using assembly tool - T10053- and centre bolt.
- Install crankshaft sprocket.
- Specified torque of new centre bolt ⇒ 2.1 Assembly overview - toothed belt.
- How to install and tension toothed belt ⇒ 2.2 Removing and installing toothed belt.
Tightening torques on this page
2 torques
In the steps
| Step | Torque |
|---|---|
| Torque wrench (5 … 50 Nm) - V.A.G 1331- | 50 Nm |
| Torque wrench (40 … 200 Nm) - V.A.G 1332- | 200 Nm |