1.6 TDI CR engine (EA189) · Crankshaft group · Cylinder block (pulley end)

Removing and installing sealing flange on pulley end

Removing and installing sealing flange on pulley end: drawing 1

Special tools and workshop equipment required

  • Counter-hold tool - 3415-
  • Assembly tool - T10053-
  • Torque wrench (5 … 50 Nm) - V.A.G 1331-
  • Torque wrench (40 … 200 Nm) - V.A.G 1332-
  • Hand drill with plastic brush
  • Sealant as per ⇒ Electronic Parts Catalogue (ETKA)
  • Scraper

Removing

Removing and installing sealing flange on pulley end: drawing 2
  • Remove crankshaft sprocket. To do this, lock toothed belt pulley using counterhold - 3415-.
  • Drain engine oil.
  • Remove sump ⇒ 1.2 Removing and installing sump.
  • Pull off front sealing flange.
  • Remove sealing flange; if necessary, loosen by applying light blows with a rubber-headed hammer.
  • Remove sealant residue from cylinder block with a flat scraper.
Removing and installing sealing flange on pulley end: drawing 3
  • Remove residual sealant from sealing flange using a plastic rotary brush (wear eye protection).
  • Clean sealing surfaces. They must be free of oil and grease.

Installing

Removing and installing sealing flange on pulley end: drawing 4
  • Cut off tube nozzle at forward marking (approx. 3 mm ∅ of nozzle).
Removing and installing sealing flange on pulley end: drawing 5
  • Apply silicone sealant bead as shown to the clean sealing surface of sealing flange.
  • Install sealing flange immediately and tighten all bolts lightly.
  • Tighten securing bolts for sealing flange to 15 Nm using alternate and diagonal sequence.
  • Install crankshaft sprocket.
  • Specified torque of new centre bolt.
  • Install sump ⇒ 1.2 Removing and installing sump.

Installing toothed belt and adjusting valve timing ⇒ 2.2 Removing and installing toothed belt.

Tightening torques on this page

3 torques

In the steps

StepTorque
Torque wrench (5 … 50 Nm) - V.A.G 1331-50 Nm
Torque wrench (40 … 200 Nm) - V.A.G 1332-200 Nm
Tighten securing bolts for sealing flange to 15 Nm using alternate and diagonal sequence.15 Nm

All tightening torques in this manual →