1.6 TDI CR engine (EA189) · Crankshaft group · Cylinder block (pulley end)

Removing and installing tensioner for poly V-belt

Special tools, testers, measuring instruments and auxiliary items required

Torque wrench - V.A.G 1332-

Removing

Removing and installing tensioner for poly V-belt: drawing 1
  • Loosen clips -1- + -2-, remove connecting hose on »cold side«.

Polo

Removing and installing tensioner for poly V-belt: drawing 2
  • Unscrew bolts -3, 4, 6-.
  • Carefully push coolant lines -5- slightly to the side.

Continued for all vehicles

Removing and installing tensioner for poly V-belt: drawing 3
  • Unscrew securing bolts -arrows- from charge air pipe and disconnect connector -1- from charge air pressure sender - G31-.
Removing and installing tensioner for poly V-belt: drawing 4
  • Open clamp -2-, lay coolant hose -3- to side and remove charge air pipe.
  • Remove air conditioner compressor; do not detach refrigerant lines on air conditioner compressor.
  • Refrigerant circuit remains closed.
  • Use suitable means to suspend air conditioner compressor on body ⇒ Heating, air conditioning; Rep. gr. 87; Air conditioner compressor; Removing and installing air conditioner compressor.
Removing and installing tensioner for poly V-belt: drawing 5
  • Unscrew securing bolt -2-.

Polo

Removing and installing tensioner for poly V-belt: drawing 6
  • Pull tensioning element forwards slightly.
Removing and installing tensioner for poly V-belt: drawing 7
  • Turn tensioning element clockwise through 180°.
Removing and installing tensioner for poly V-belt: drawing 8
  • Pull tensioning element under alternator downwards at an angle out of its retainer.

Installing

Tensioning element installation is carried out in the reverse sequence of removal. During this procedure, observe the following:

Removing and installing tensioner for poly V-belt: drawing 9
  • Screw tensioning element under alternator into its retainer.
Removing and installing tensioner for poly V-belt: drawing 10
  • Turn tensioning element anticlockwise through 180°.
Removing and installing tensioner for poly V-belt: drawing 11
  • Guide tensioning element into its retainer.
Removing and installing tensioner for poly V-belt: drawing 12

Restore coolant lines -5- to their installation position, tighten -3, 4, 6-. 8 Nm.

Continued for all vehicles

Tightening torques on this page

1 torque

In the steps

StepTorque
Restore coolant lines -5- to their installation position, tighten -3, 4, 6-. 8 Nm.8 Nm

All tightening torques in this manual →