1.6 TDI CR engine (EA189) · Crankshaft group · Cylinder block, gearbox end
Cylinder block, gearbox end – assembly overview and fastening
- 1 Bolt
- Renew
- 60 Nm +90°
- 2 Flywheel
- Removing and installing flywheel ⇒ 2.2 Removing and installing flywheel
- Offset holes make assembly possible in one position only
- 3 Sender wheel
- For engine speed sender - G28-
- Removing and installing ⇒ 2.3 Removing and installing sealing flange on gearbox side
- 4 Engine speed sender - G28-
- Removing and installing ⇒ 1.4 Removing and installing engine speed sender - G 28-
- 5 Bolt
- 4.5 Nm
- 6 Dowel pin
- Qty. 2
- 7 Intermediate plate
- Do not damage or bend when assembling.
- Installing ⇒ 2.1 Assembly overview - cylinder block, gearbox end
- 8 Sealing flange with oil seal
- Removing and installing ⇒ 2.3 Removing and installing sealing flange on gearbox side.
- With sender wheel for engine speed.
- Renew complete only.
- Do not additionally oil or grease the oil seal sealing lip.
- Before installing, remove oil residue from crankshaft journal using a clean cloth.
- Use support sleeve supplied when installing.
- 9 Bolt
- Specified torque and tightening sequence ⇒ 2.1 Assembly overview - cylinder block, gearbox end
Installing intermediate plate
- Attach intermediate plate to sealing flange -arrow at top- and push onto dowel pins -arrows at bottom-.

Sealing flange on gearbox side - specified torque and tightening sequence
- Tighten bolts in 2 stages as follows:
| Stag e | Bolts | Specified torque |
|---|---|---|
| 1) | -1 … 6- | Screw in by hand as far as stop |
| 2) | -1 … 6- | In diagonal sequence and in stages; final torque 15 Nm |
Tightening torques on this page
3 torques
| Part | Torque |
|---|---|
| 2) | In diagonal sequence and in stages; final torque 15 Nm |

