1.6 TDI CR engine (EA189) · Crankshaft group · Pistons and conrods

Checking radial clearance of conrods

Special tools and workshop equipment required

  • Plastigage

Removing

  • Remove conrod bearing cap. Clean bearing cap and bearing journal.
  • Place a Plastigage corresponding to the width of the bearing on the journal or into the bearing shells.
  • Fit conrod bearing cap and tighten to 30 Nm without turning further angle and without rotating crankshaft.
  • Remove conrod bearing cap again.
  • Compare width of Plastigage with the measurement scale.

Radial clearance:

  • Wear limit: 0.08 mm
  • Renew conrod bolts.

Tightening torques on this page

1 torque

In the steps

StepTorque
Fit conrod bearing cap and tighten to 30 Nm without turning further angle and without rotating crankshaft.30 Nm

All tightening torques in this manual →