Removing and installing glass panel

Special tools and workshop equipment required

• Torque wrench 210 Nm - V.A.G 1783-

Removing

• Open sun blind completely.
• Push trim -1- slightly towards rear -arrow a-.
• Remove trim -1- from sliding sunroof frame -2- -arrow b-.

• Open glass panel of panorama tilting roof by 150 mm -dimension a-.
• Undo rear securing bolts -2-.
• Loosen rear securing bolts -4- on left and right but do not undo completely.
• Unscrew front securing bolts -3- on left and right.
• Lift out glass panel -1- upwards.

Installing

• Open mechanism by 150 mm -dimension a- with the pushbutton.
• Place glass panel -1- on the tilting mechanism.
• Lightly tighten securing bolts -2, 3 and 4- on left and right.
• Adjust panorama tilting sunroof glass panel (height adjustment): ⇒ 1.9 Adjusting glass panel

• Insert trim -1- into sliding sunroof frame -2- -arrow a-.
• Push trim -1- rearwards slightly -arrow b-.