Body repairs – exterior · Sunroof · Sliding sunroof

Removing and installing sliding sunroof adjustment control unit J245

Special tools and workshop equipment required

Removing and installing sliding sunroof adjustment control unit J245: drawing 1
  • Torque wrench 210 Nm - V.A.G 1783-

Removing

The requirements for removing and installing drive are: Engine not running and ignition off, key not in ignition and door open.

Removing and installing sliding sunroof adjustment control unit J245: drawing 2

Perform the following steps:

  • This situation must be maintained until drive has been installed.
  • Remove bolts -4- and pull off drive for panorama tilting roof -1-.
  • Detach drive connector -5-.

Installing

Removing and installing sliding sunroof adjustment control unit J245: drawing 3

Perform the following steps:

  • Plug in connector -5- at drive -1-.
  • Check that the clips -2- are correctly seated.
  • Fit drive -1-, and tighten bolts -4-. Specified torque: 4 Nm.
  • After installation, the key can be inserted in ignition and starter switch again.
  • Then test for proper function.

Tightening torques on this page

2 torques

In the steps

StepTorque
Torque wrench 210 Nm - V.A.G 1783-210 Nm
Fit drive -1-, and tighten bolts -4-. Specified torque: 4 Nm.4 Nm

All tightening torques in this manual →