1.6 TDI CR engine (EA189) · Cylinder head, valve gear · Cylinder head
Cylinder head – assembly overview and fastening
- 1 Cylinder head
- Removing and installing ⇒ 1.2 Removing and installing cylinder head.
- After renewing, renew entire coolant
- 2 Washer
- For cylinder head bolt
- 3 Cylinder head bolt
- Observe sequence when loosening and tightening ⇒ 1.2 Removing and installing cylinder head.
- Before installing, place washers in cylinder head ⇒ Item 2 (1.1 Assembly overview - cylinder head)
- 4 Oil pressure switch - F1-, 22 Nm
- Identification: green
- 0.5 bar
- If seal is leaking, nip open and renew.
- Checking ⇒ 3.3 Checking oil pressure and oil pressure switch
- 5 20 Nm
- 6 Lifting eye
- 7 Glow pin plug, 18 Nm
- 8 Seal
- Renew
- 9 Vacuum pump
- 10 10 Nm
- 11 Clip
- 12 G 62
- Radiator outlet coolant
- 13 Seal
- Renew
- 14 10 Nm
- 15 Coolant hose connection
- 16 Seal
- Renew
- 17 25 Nm
- 18 Lifting eye
- 19 Cylinder head gasket
- Renew
- Observe identification ⇒ 1.1 Assembly overview - cylinder head.
- After renewing, renew entire coolant
- 20 Hall sender - G40-
- For camshaft position
- To remove or install, toothed belt must be removed from camshaft pulley, and idler roller must be loosened.
- 21 10 Nm

Checking cylinder head for distortion
- Use straight edge 500 mm - VAS 6075- and feeler gauge to measure cylinder head for distortion at several points.
Max. permissible distortion: 0.1 mm

Cylinder head gasket identification
- 1 Part number
- 2 Holes
- 3 Ignore
