1.6 TDI CR engine (EA189) · Cylinder head, valve gear · Valve gear
Measuring radial play of camshaft
Special tools and workshop equipment required
- Plastigage
Procedure
- Remove roller rocker finger.
- Remove bearing cap and clean crankshaft journal.
- Place a length of Plastigage corresponding to the width of the bearing on the journal to be measured or into the bearings.
- Plastigage must lie in the middle of the bearing.
- Fit retaining frame and tighten to 10 Nm ⇒ 3.1 Assembly overview - valve gear without twisting crankshafts.
- Remove retaining frame.
- Compare width of Plastigage with the measurement scale.
- Radial clearance: 0.035 to 0.085 mm.
Tightening torques on this page
1 torque
In the steps
| Step | Torque |
|---|---|
| Fit retaining frame and tighten to 10 Nm ⇒ 3.1 Assembly overview - valve gear without twisting crankshafts. | 10 Nm |