1.6 TDI CR engine (EA189) · Lubrication · Oil filter, oil pressure switch
Checking oil pressure and oil pressure switch
⇒ 3.3.2 Checking oil pressure switch
3.3.1 Checking oil pressure
Special tools and workshop equipment required

- Oil pressure tester - V.A.G 1342-
Procedure
- Oil level OK.
- Engine oil temperature approx. 80°C.
- Remove oil pressure switch - F1- ⇒ 3.4 Removing and installing oil pressure switch - F1-.
- Connect oil pressure tester - V.A.G 1342- to hole for oil pressure switch - F1-.
- Screw an old oil pressure switch into hole on oil pressure tester - V.A.G 1342- to seal hole.
- Start engine.
- Oil pressure at idling speed: at least 0.6 bar.
- Increase engine speed further. At 2,000 rpm and an oil temperature of 80°C; the oil pressure should be at least 1.0 bar.
At higher engine speeds, the oil pressure must not exceed 5.0 bar. If oil pressure exceeds 5.0 bar:
- Renew oil pump.
3.3.2 Checking oil pressure switch

Special tools and workshop equipment required
- Oil pressure tester - V.A.G 1342-
- Voltage tester - V.A.G 1527 B-
- Adapter set - V.A.G 1594 C-
Test conditions
- Oil level OK, checking ⇒ 1.5.2 Checking engine oil level
- Engine oil temperature at least 80°C (radiator fan must have run once)
- Remove oil pressure switch - F1- ⇒ 3.4 Removing and installing oil pressure switch - F1-.

- Connect oil pressure tester - V.A.G 1342- in hole for oil pressure switch.
- Screw oil pressure switch - F1- -item 2- into hole in oil pressure tester.
- Connect brown line -1- of oil pressure tester to earth (–).
- Connect voltage tester - V.A.G 1527 B- to battery positive (+) and oil pressure switch - F1- using cables from auxiliary test set - V.A.G 1594 C-.
- LED should not light up.
- Start engine.
- If LED does not light up, renew oil pressure switch - F1- ⇒ 3.4 Removing and installing oil pressure switch - F1-.