1.6 TDI CR engine (EA189) · Cylinder head, valve gear · Valve gear

Removing and installing camshaft oil seal

Removing and installing camshaft oil seal: drawing 1
Removing and installing camshaft oil seal: drawing 2

Special tools and workshop equipment required

  • Fitting tool - V.A.G 10-203-
  • Seal puller - 3240-
  • Torque wrench - V.A.G 1331/-
  • Torque wrench - V.A.G 1332/-
  • Use bolt M12 x 1.5 x 75 -10203-.
Removing and installing camshaft oil seal: drawing 3

Puller - T10443- for “new version” of oil seal

Removing

“Old version” of oil seal:

Removing and installing camshaft oil seal: drawing 4
  • Insert thrust piece -3240/1- into camshaft.
  • Unscrew inner part of oil seal extractor - 3240- 2 turns (approx. 3 mm) from the outer part and lock in position with the knurled screw.
Removing and installing camshaft oil seal: drawing 5
  • Lubricate threaded head of oil seal extractor, place it in position and, exerting firm pressure, screw it into oil seal as far as possible.
  • Loosen knurled screw and turn inner part against camshaft until oil seal is pulled out.
  • Clamp oil seal extractor on flats in a vice and remove oil seal using pliers.
Removing and installing camshaft oil seal: drawing 6

“New version” of oil seal:

  • Carefully unscrew grub screw -arrow- of puller -T10443- until a slight resistance is felt.
Removing and installing camshaft oil seal: drawing 7
  • Position puller - T10443- such that it is straight, as shown in illustration, and lock it in place by screwing in grub screw -A-.
  • Screw in thrust bolt -B- until oil seal is extracted.

Installing

  • Clean contact surface and sealing surface.
  • Remove oil residue from camshaft journal using a clean cloth.
Removing and installing camshaft oil seal: drawing 8
  • Fit guide sleeve -10-203- onto camshaft as shown in illustration.
  • Carefully slide oil seal -1- over guide sleeve onto camshaft.
Removing and installing camshaft oil seal: drawing 9