1.6 TDI CR engine (EA189) · Cylinder head, valve gear · Cylinder head
Removing and installing vacuum pump
Removing
Polo
- Remove air filter housing together with air mass meter and connecting pipe ⇒ 7.2.2 Removing and installing air filter housing, Polo.
Continued for all vehicles

- Pull vacuum line -1- off vacuum pump -2-.
- Unscrew securing bolts of charge air pipe, and then push charge air pipe down slightly to gain access to rear threaded connection of vacuum pump.

- Unscrew vacuum pump securing bolts -arrows-.
- Remove vacuum pump -2- from cylinder head.
Installing
Installation is carried out in the reverse order. When installing, note the following:
- Install vacuum pump and tighten securing bolts to 10 Nm.
- Connect brake servo vacuum line to vacuum pump -1-.
Tightening torques on this page
1 torque
In the steps
| Step | Torque |
|---|---|
| Install vacuum pump and tighten securing bolts to 10 Nm. | 10 Nm |