1.6 TDI CR engine (EA189) · Glow plug system · Glow plug system

Removing and installing engine speed sender G 28

Special tools and workshop equipment required

Removing and installing engine speed sender G 28: drawing 1
  • Hexagon key extension, 4 mm - T10370-
Removing and installing engine speed sender G 28: drawing 2
  • Assembly tool - T10118-
  • Remove noise insulation:

    Polo ⇒ General body repairs, exterior; Rep. gr. 50; Noise insulation; Assembly overview - noise insulation

Polo

Removing and installing engine speed sender G 28: drawing 3
  • Remove bolts -3- and secure coolant circulation pump 2 - V178- with coolant hoses still connected -arrows- on righthand side.

Continuation for all vehicles

Removing and installing engine speed sender G 28: drawing 4
  • Disconnect electrical connector -1- at engine speed sender - G28- using assembly tool - T10118-.
Removing and installing engine speed sender G 28: drawing 5
  • Remove securing bolt -arrow- and pull out engine speed sender - G28-.

Installation is performed in the reverse order, observing the following: specified torques for engine speed sender - G28- securing bolt: 5 Nm.

Polo

Tightening torques on this page

1 torque

In the steps

StepTorque
Installation is performed in the reverse order, observing the following: specified torques for engine speed sender - G28- securing bolt: 5 Nm.5 Nm

All tightening torques in this manual →