SSP 390 The 7-speed Double-clutch Gearbox 0AM
Drive shafts, output shafts and differential
Drive shafts

The drive shafts are located in the gearbox housing. Each drive shaft is connected to a clutch via splines. These transfer the engine torque onto the output shafts according to the gear which is engaged. Drive shaft 2 is hollow. Drive shaft 1 runs through hollow drive shaft 2. A ball bearing, which is used to mount the drive shafts in the gearbox housing, is located on each shaft.

Drive shaft 2
Due to its installation position, drive shaft 2 will be described before drive shaft 1.

Drive shaft 2 is designed as a hollow shaft. It is connected to K2 via splines. Drive shaft 2 is used to shift gears 2, 4, 6 and R. To record the gearbox input speed, this shaft has the gear for gearbox input speed sender 2 G612.
Drive shaft 1

Drive shaft 1 is connected to clutch K1 via splines. It is used to shift gears 1,3,5 and 7. To record the gearbox input speed, this shaft has the impulse wheel for gearbox input speed sender 1 G632.
Output shafts

Three output shafts are contained in the gearbox housing. Depending on the gear which is engaged, the engine's torque is transferred from the drive shafts to the output shafts. An output gear, via which the torque is passed on to the differential final drive gear, is located on each output shaft.
Output shaft 1

The following are located on output shaft 1:
- The selector gears for gears 1, 2 and 3; the 3 gears are synchromeshed 3-fold.
- The selector gear for 4th gear; the 4th gear is synchromeshed 2-fold.
Output shaft 2


The following are located on output shaft 2:
- The 2-fold synchromeshed selector gears for gears 5, 6 and 7, and
- The intermediate gears R gear 1 and R gear 2 for reverse gear.
Output shaft 3


The following are located on output shaft 3:
- The 1-fold synchromeshed selector gear for R gear
- The parking lock gear
Differential


The differential transfers the torque onwards to the vehicle's wheels via the drive shafts.