7-speed DSG gearbox 0AM (DQ200) · Final Drive, Differential · Seals

Right Flange Shaft Seal, Replacing

Left side. Refer to ⇒ 1.5 Left Flange Shaft Seal, Replacing.

Special tools and workshop equipment required

  • Seal Installer - Flange Shaft - 3305-
  • Tensioning Strap - T10038-
  • Socket And Extended Bit - T10107A- or Long Hex Socket - VAG1669-
  • Used Oil Collection and Extraction Unit - SMN372500-
  • Sealing Grease - G 052 128 A1-

Removing

Right Flange Shaft Seal, Replacing: drawing 1
  • Remove the noise insulation. Refer to ⇒ Body Exterior; Rep. Gr. 50; Noise Insulation.
Right Flange Shaft Seal, Replacing: drawing 2
  • If equipped, remove the drive axle heat shield from the engine -arrows-.
  • Remove right drive axle from transmission flange shaft.
  • Tie up the drive axle as high as possible. Do not damage the paint on the drive axle.
  • Place the Used Oil Collection and Extraction Unit - SMN372500- or Drip Tray under the transmission.
Right Flange Shaft Seal, Replacing: drawing 3
  • Remove the right flange shaft bolt at the transmission using the Socket And Extended Bit - T10107A-. Insert two bolts in the flange and counterhold with a tire iron.

The bolt has 6 mm inner hex. The bolt can also be removed and installed using the Long Hex Socket - VAG1669-.

  • Remove the flange shaft.
  • Pry out the sealing ring.

Installing

  • Lightly oil the new gasket on the outer circumference.
Right Flange Shaft Seal, Replacing: drawing 4
  • Fill the space with the new seal between the sealing and dust lip halfway with Sealing Grease - G 052 128- -arrow-.
Right Flange Shaft Seal, Replacing: drawing 5
  • Drive in the new seal all the way using the Seal Installer - Flange Shaft - 3305-. Do not tilt the seal.
  • Install the flange shaft.
  • Tighten the new screw to 30 Nm. Push the flange shaft against the transmission so that the bolt engages in the thread.
  • Attach the right drive axle to the flange shaft or install the right drive axle. Refer to ⇒ Suspension, Wheels, Steering; Rep. Gr. 40; Drive Axles, Removing and Installing.
  • Refill any transmission fluid that may have leaked out while removing the seal. Refer to ⇒ 1 Transmission Fluid, Replacing.
  • Install the noise insulation. Refer to ⇒ Body Exterior; Rep. Gr. 50; Noise Insulation.

Tightening torques on this page

1 torque

In the steps

StepTorque
Tighten the new screw to 30 Nm. Push the flange shaft against the transmission so that the bolt engages in the thread.30 Nm

All tightening torques in this manual →