1.6 TDI CR engine (EA189) · Exhaust system · Exhaust pipes and silencers

Aligning exhaust system free of stress

⇒ 1.2.2 Aligning exhaust system free of stress, Polo

1.2.2 Aligning exhaust system free of stress, Polo

Special tools and workshop equipment required

Aligning exhaust system free of stress: drawing 1
  • Torque wrench - V.A.G 1331-

Condition

  • The exhaust system is cold.
Aligning exhaust system free of stress: drawing 2

Procedure

  • Loosen threaded connections of the front clamp.
  • Align clamp on front exhaust pipe under consideration of dimension -a-. Dimension -a- = 5 mm
Aligning exhaust system free of stress: drawing 3
  • Align clamp so that bolt ends do not protrude beyond lower edge of clamp -arrow-.
  • Tighten front threaded connection of clamp slightly.
Aligning exhaust system free of stress: drawing 4
  • Then align exhaust system with mountings under consideration of dimension -a-. -Arrow- points in direction of travel. Dimension -a- = 3 … 7 mm.
Aligning exhaust system free of stress: drawing 5
  • Then evenly tighten securing nuts -arrows- of foremost clamp. Specified torque: M8 = 25 Nm, M10 = 40 Nm.
  • Once clamp has been tightened, check set-up dimensions and correct if necessary.

Tightening torques on this page

1 torque

1.2.2 Aligning exhaust system free of stress, PoloTo the steps ↑

StepTorque
Then evenly tighten securing nuts -arrows- of foremost clamp. Specified torque: M8 = 25 Nm, M10 = 40 Nm.25 Nm / 40 Nm

All tightening torques in this manual →