1.6 TDI CR engine (EA189) · Exhaust system · Exhaust pipes and silencers

Installation position of clamp

Installation position of clamp: drawing 1

Specified torque and mounting dimensions of clamping sleeve.

Clamp -A- with 2 individual clips.

Specified torque: 25 Nm

Installation dimensions -a- 5 mm (only for front clamp)

Clamp -B- with continuous clip.

Specified torque: 35 Nm

Installation dimensions -a- 6.6 mm (only for front clamp)

Installation position of clamp: drawing 2

Installation dimension -a- for vehicles with marking on front exhaust pipe

  • 1 Clamping sleeve
  • 2 Front exhaust pipe

a - Installation dimension

A - Marking

Installation position of clamp: drawing 3

Installation position of front clamp

  • Install clamp so that end of bolt -arrow- does not extend beyond lower edge of clamp.
  • Threaded connection faces right
Installation position of clamp: drawing 4

Installation position of rear clamp

  • Install clamp so that end of bolt -arrow- does not extend beyond lower edge of clamp.
  • Threaded connection faces to rear.

Specified torque: M8 = 25 Nm, M10 = 40 Nm

Tightening torques on this page

3 torques

In the steps

StepTorque
Specified torque: 25 Nm25 Nm
Specified torque: 35 Nm35 Nm
Specified torque: M8 = 25 Nm, M10 = 40 Nm25 Nm / 40 Nm

All tightening torques in this manual →