1.6 TDI CR engine (EA189) · Cooling · Coolant pump, regulation of cooling system
Removing and installing coolant pump

Special tools and workshop equipment required
- Refractometer - T10007-
- Drip tray for workshop hoist - VAS 6208-
- Torque wrench (5 … 50 Nm) - V.A.G 1331-
- Pliers for spring-type clips - VAS 6362-
Removing
- Drain coolant ⇒ 1.3 Draining and adding coolant.
- Remove poly V-belt ⇒ 13 – Crankshaft group.
- Remove toothed belt ⇒ 2.2 Removing and installing toothed belt.
Vehicles with supplementary or auxiliary heating
- Remove coolant pipes on right
Continued for all vehicles

- Remove securing bolts -1- for coolant pump -2- and carefully remove coolant pump.
Installing
Installation is carried out in the reverse order. When installing, note the following:

- Moisten new O-ring -3- with coolant.
- Insert coolant pump -2- in cylinder block, and tighten securing bolts -1- to 15 Nm.
- Install toothed belt ⇒ 2.2 Removing and installing toothed belt.
- Install poly V-belt ⇒ 13 – Crankshaft group.
- Add coolant ⇒ 1.3.2 Filling with coolant.
Tightening torques on this page
2 torques
In the steps
| Step | Torque |
|---|---|
| Torque wrench (5 … 50 Nm) - V.A.G 1331- | 50 Nm |
| Insert coolant pump -2- in cylinder block, and tighten securing bolts -1- to 15 Nm. | 15 Nm |