1.6 TDI CR engine (EA189) · Cooling · Coolant pump, regulation of cooling system

Electric coolant pump

⇒ 2.6.1 Removing and installing coolant circulation pump 2 V178, Polo

2.6.1 Removing and installing coolant circulation pump 2 - V178-, Polo

Special tools and workshop equipment required

Electric coolant pump: drawing 1
  • Hose clamps to 25 mm - 3094-
Electric coolant pump: drawing 2
  • Spring-type clip pliers - VAS 6362-

Removing

  • Remove noise insulation:

    Polo ⇒ General body repairs, exterior; Rep. gr. 50; Noise insulation; Assembly overview - noise insulation

Electric coolant pump: drawing 3
  • Clamp off coolant hoses with hose clamps -3094- and remove: to do this, loosen hose clips -arrows-.
  • Disconnect connector -2-.
  • Undo bolt -3- and remove coolant circulation pump 2 - V178-.

Installing

Install in reverse order of removal, observing the following.

  • Install noise insulation:

    Polo ⇒ General body repairs, exterior; Rep. gr. 50; Noise insulation; Assembly overview - noise insulation

  • Check coolant level ⇒ 1.3 Draining and adding coolant.