1.6 TDI CR engine (EA189) · Cooling · Coolant pump, regulation of cooling system

Removing and installing coolant temperature sender

⇒ 2.7.1 Removing and installing coolant temperature sender G62

⇒ 2.7.3 Removing and installing radiator outlet coolant temperature sender G83, Polo

2.7.1 Removing and installing coolant temperature sender - G62-

Special tools and workshop equipment required

Removing and installing coolant temperature sender: drawing 1
  • Release lever - 80 - 200-
Removing and installing coolant temperature sender: drawing 2

Removing

  • Engine cold.
Removing and installing coolant temperature sender: drawing 3
  • Pull off crankcase breather hose -1- from cylinder head cover by pressing the release buttons.
  • Release connector on hose -1- for crankcase bleeding and pull off.
  • Free vacuum hoses -arrows- at air pipe.
  • Unscrew bolt -2-, swing air pipe with inlet pipe to rear and remove from turbocharger.
Removing and installing coolant temperature sender: drawing 4

Vehicles with dual clutch gearbox

  • Pull off coolant hoses from gearbox oil cooler by undoing hose clips -arrows-.
Removing and installing coolant temperature sender: drawing 5

Continued for all vehicles

  • Remove bolt -arrows-.
  • Free electrical wiring and hoses on left air pipe using removal lever - 80 - 200-.
  • Loosen hose clip -3- and press left air pipe with coolant pipe aside.
Removing and installing coolant temperature sender: drawing 6
  • Unlock and pull connector -4- off coolant temperature sender - G62-.
  • Pull off retaining clip -3- and pull coolant temperature sender - G62- out of screw connection.

Installing

Install in reverse order. During this procedure, observe the following:

  • Check coolant level.

2.7.3 Removing and installing radiator outlet coolant temperature sender - G83-, Polo

Removing and installing coolant temperature sender: drawing 7

Removing

  • Engine cold.
  • Briefly open filler cap -1- for coolant expansion tank in order to reduce pressure in cooling system.
  • Remove noise insulation:

    Polo ⇒ General body repairs, exterior; Rep. gr. 50; Noise insulation; Assembly overview - noise insulation

Removing and installing coolant temperature sender: drawing 8
  • Disconnect connector -2-.
  • Pull off retaining clip -1- and pull coolant temperature sender at radiator outlet - G83- -item 3- out of connection of coolant pipe.

Installing

Install in reverse order of removal, observing the following.

  • Install noise insulation:

    Polo ⇒ General body repairs, exterior; Rep. gr. 50; Noise insulation; Assembly overview - noise insulation

  • Check coolant level.