1.6 TDI CR engine (EA189) · Cooling · Coolant pump, regulation of cooling system
Removing and installing thermostat

Special tools and workshop equipment required
- 10 mm jointed spanner - 3185-
- Refractometer - T10007-
- Multi-point bit - T10058-
- Torque wrench - V.A.G 1331/-
- Drip tray for workshop hoist - VAS 6208-
- Hose clamp pliers - VAS 6340-
Removing
- Drain coolant ⇒ 1.3 Draining and adding coolant.

- Unscrew bolts -arrows-.
- Free off coolant hose -3-.
- Disconnect electrical connection -1- on charge pressure sender - G31- / intake air temperature sensor - G42- and remove right charge air pipe.

- Disconnect coolant hose from union, loosen hose clip -1- for this.
- Loosen union securing bolts -arrows- using T-bar and 10 mm socket - 3185- and unscrew with 5 mm Allen key extension - T10058- and remove union with thermostat -1-.

- Turn thermostat -2- approx. 15° clockwise -arrow- and remove from union.
- Remove O-ring -1-.
Installing
- Specified torque ⇒ 2.1.1 Assembly overview - coolant pump, thermostat.
Install in reverse order of removal, observing the following.
- Clean and smoothen sealing surface for O-ring.
- Moisten O-ring with coolant.

- Insert thermostat -3- with O-ring -2- in guides on union -1-.

- Turn thermostat -1- anticlockwise -arrow- to stop.
- Install charge air pipe.
- Polo: Install connecting hoses with screw-type clips ⇒ 2.1.3 Assembly overview - charge air system, Polo.
- Add coolant ⇒ 1.3.2 Filling with coolant.