1.6 TDI CR engine (EA189) · Lubrication · Engine oil cooler

Removing and installing engine oil cooler

Special tools and workshop equipment required

Removing and installing engine oil cooler: drawing 1
  • Used oil collection and extraction unit - V.A.G 1782-
Removing and installing engine oil cooler: drawing 2
  • Drip tray for workshop hoist - VAS 6208-
Removing and installing engine oil cooler: drawing 3
  • Spring-type clip pliers - VAS 6362-

Removing

Polo

Continued for all vehicles

Removing and installing engine oil cooler: drawing 4
  • In addition to draining coolant from engine, pull coolant hose from oil filter holder -arrow-.
Removing and installing engine oil cooler: drawing 5
  • Remove oil filter element.
Removing and installing engine oil cooler: drawing 6
  • Unscrew bolts -arrows-.
  • Remove oil cooler from housing.

Installing

Install in reverse order.

Removing and installing engine oil cooler: drawing 7
Removing and installing engine oil cooler: drawing 8
  • Press oil cooler on until it is flush -1- with end of centring pins.
  • Start new bolts, and screw them in until heads make contact.
Removing and installing engine oil cooler: drawing 6
  • Tighten bolts -arrows- in 3 stages and in diagonal sequence.
  • Step 1: tighten by hand
  • Step 2: tighten to 5 Nm
  • Step 3: tighten to 11 Nm

Tightening torques on this page

2 torques

In the steps

StepTorque
Step 2: tighten to 5 Nm5 Nm
Step 3: tighten to 11 Nm11 Nm

All tightening torques in this manual →