1.6 TDI CR engine (EA189) · Lubrication · Engine oil cooler
Checking engine oil cooler for leaks

Special tools and workshop equipment required
- Refractometer - T10007-
- Hose clamps up to 25 mm - 3094-
- Cooling system tester - V.A.G 1274-
- Adapter for cooling system tester - V.A.G 1274/8-
- Pliers for spring-type clips - VAS 5024 A-
- Drip tray for workshop hoist - VAS 6208-

- Torque wrench - V.A.G 1331-
Without illustration:
- Expansion tank - 1K0 121 407 A- or expansion tank - 1J0 121 407 B-
- Plugs - 191 211 343-
- Sealing cap - 1J0 121 324-
- Coolant hose - 251 265 056-
Condition:
- Engine cold
Test sequence
- Remove noise insulation:
Polo ⇒ General body repairs, exterior; Rep. gr. 50; Noise insulation; Assembly overview - noise insulation
- Drain coolant ⇒ 1.3 Draining and adding coolant.
- Loosen hose clips on engine oil cooler using spring type clip pliers - VAS 5024-.
- Remove engine oil cooler with housing ⇒ 3.1 Assembly overview - oil filter housing.

Checking when removed
- Clamp housing with old seal on a suitable, level clean surface.
- Secure sealing plug -2- to breather connection of expansion tank -1-.
- Secure coolant hose -3- to engine oil cooler and expansion tank.
- Fill expansion tank up to “Max” marking.
- Attach cooling system tester - V.A.G 1274- with cooling system tester adapter - V.A.G 1274/8- to expansion tank.
- Use hand pump on tester to create a pressure of about 1.6 bar.
- Watch pressure drop on pressure gauge. A pressure drop within 10 minutes is not permitted.
If the pressure drops:
- Renew engine oil cooler ⇒ 2.2 Removing and installing engine oil cooler.
Installation is carried out in the reverse order. When installing, note the following:
- Renew seal for housing.
- Check coolant level, replenish if necessary ⇒ 1.3.2 Filling with coolant.
- Check engine oil level, replenish if necessary ⇒ 1.5.2 Checking engine oil level.