1.6 TDI CR engine (EA189) · Lubrication · Oil filter, oil pressure switch

Removing and installing oil filter housing

Special tools and workshop equipment required

Removing and installing oil filter housing: drawing 1
  • Release lever - 80 - 200-
Removing and installing oil filter housing: drawing 2
  • Used oil collection and extraction unit - V.A.G 1782-
Removing and installing oil filter housing: drawing 3
  • Drip tray for workshop hoist - VAS 6208-
Removing and installing oil filter housing: drawing 4
  • Spring-type clip pliers - VAS 6362-

Removing

Polo

  • Remove air intake cowling.

Continued for all vehicles

Removing and installing oil filter housing: drawing 5
  • Remove oil filter element.
Removing and installing oil filter housing: drawing 6
  • Loosen hose clamps -1- and -2- and remove air hose.
Removing and installing oil filter housing: drawing 7
  • Unscrew bolts -arrows-.
  • Free off coolant hose -3-.
  • Release hose clip -2-.
  • Disconnect electrical connection -1- on charge pressure sender - G31- / intake air temperature sensor - G42- and remove right charge air pipe.
Removing and installing oil filter housing: drawing 8
  • Pull out oil dipstick slightly, unscrew bolt -1-.
  • Press off clip -2- using removal lever - 80 - 200-.
  • Pull oil dipstick guide tube off cylinder block upwards and push to side.
Removing and installing oil filter housing: drawing 9
  • Place drip tray for workshop hoist - VAS 6208- under point of separation.
  • Remove coolant hoses. To do this, loosen hose clips -1-.
  • Place used oil collection and extraction unit - V.A.G 1782- under engine.
  • Unscrew bolts -arrows- and remove oil filter bracket with engine oil cooler.

Installing

Install in reverse order of removal, observing the following.