1.6 TDI CR engine (EA189) · Lubrication · Sump, oil pump
Sump/oil pump – assembly overview and fastening
- 1 Oil level and oil temperature sender - G266-
- Removing and installing ⇒ 1.3 Removing and installing oil level and oil temperature sender - G 266-
- 2 O-ring
- Renew
- 3 Oil drain plug
- 30 Nm
- 4 Seal
- Renew
- 5 Bolt
- Specified torque and tightening sequence ⇒ Fig. ““Sump - specified torque and tightening sequence”“, page 222
- 6 Sump
- Clean sealing surface before fitting.
- Install with sealant according to ⇒ Electronic Parts Catalogue (ETKA).
- Removing and installing ⇒ 1.2 Removing and installing sump
- 7 Bolt
- 16 Nm
- 8 Oil pump
- With 12 bar pressure relief valve
- Before installing, check that both dowel sleeves for centring oil pump on cylinder block are fitted.
- Check oil pump for ease of movement.
- It should be possible to turn belt pulley easily with 1 finger.
- Replace if difficult to turn.
- Removing and installing ⇒ 1.4 Removing and installing oil pump
- 9 Toothed belt
- Check for damage and wear
- Replace if necessary
- 10 Dowel sleeves
- 11 Cylinder block
- 12 O-ring
- Renew
- 13 Bolt
- 9 Nm
- 14 Clip
- 15 Dipstick guide tube
- 16 Bolt
- 9 Nm
- 17 Oil intake tube
- 18 Baffle plate
- 19 Bolt
- 16 Nm
- 20 Bolt
- Self-locking
- Renew
- 9 Nm

Sump - specified torque and tightening sequence
| Stage | Bolts | Specified torque |
|---|---|---|
| 1) | -1 … 20- | In diagonal sequence to 5 Nm |
| 2) | -Arrows- | 40 Nm |
| 3) | -1 … 20- | Diagonally in stages; final torque 13 Nm |

Oil spray jet and pressure relief valve
- 1 Bolt with pressure relief valve, 27 Nm
- 2 Oil spray jet (for cooling of pistons)
Tightening torques on this page
10 torques
| Part | Torque |
|---|---|
| 1) | In diagonal sequence to 5 Nm |
| 2) | 40 Nm |
| 3) | Diagonally in stages; final torque 13 Nm |
