7-speed DSG gearbox 0AM (DQ200) · Clutch · Dual Clutch, Removing and Installing, through Transmission Production Date 05/2011
Overview – Dual Clutch, through Transmission Production Date 05/2011
- 1 Circlip
- Always replace after removing
- 2 Hub
- 3 Circlip
- Always replace after removing
- 4 Large Engaging Lever for “K 1”
- With large engaging bearing
- Always replace when replacing the dual clutch
- 5 Small Engaging Lever for »K 2«
- Always replace when replacing the dual clutch
6 - Bolts
- 8 Nm +90°
- Always replace after removing
- 7 Support
- For engaging lever
- Always replace when replacing the dual clutch
- 8 Bracket
- For small engaging lever
- Not equipped on some older transmissions
- Always replace when replacing the dual clutch
- 9 Seal
- For the inner input shaft
- Replacing. Refer to ⇒ 3 Clutch-Side Seals, Removing and Installing.
- 10 Seal
- For the outer input shaft
- Replacing. Refer to ⇒ 3 Clutch-Side Seals, Removing and Installing.
- 11 Outer Input Shaft
- 12 Shim “SK 2”
- Selecting thickness. Refer to ⇒ 1.3 K 1 and K 2 Clutch Engaging Bearing Position, Adjusting, Transmission Production Date through 05/2011.
- 13 Shim “SK 1”
- Selecting thickness. Refer to ⇒ 1.3 K 1 and K 2 Clutch Engaging Bearing Position, Adjusting, Transmission Production Date through 05/2011.
- 14 Small Engaging Bearing for »K 2«
- 15 Dual Clutch
- Removing. Refer to ⇒ 1.2 Dual Clutch, Removing, through Transmission Production Date 05/2011.
- Installing. Refer to ⇒ 1.4 Dual Clutch, Installing, Transmission Production Date through 05/2011.
Tightening torques on this page
1 torque
In the steps
| Step | Torque |
|---|---|
| 6 - Bolts | 8 Nm +90° |
