7-speed DSG gearbox 0AM (DQ200) · Clutch · Clutch-Side Seals, Removing and Installing
Clutch-Side Seals, Removing and Installing
Replacing the Input Shaft Seal

There are 2 seals in the transmission on the clutch side. It is possible to replace both seals -arrows- without disassembling the transmission. It is not necessary to adjust the clutch if only the seals are being replaced.
Special tools and workshop equipment required
- Press Piece - 60mm - VW415A-
- Puller - Shaft Seal - T10420-
- Seal Installer - Shaft Seal - T10421-
- Puller - Crankshaft/Power Steering Seal - T20143/2-
- Remove the transmission:
- Refer to
- Refer to ⇒ 5 Transmission, Removing and Installing, Jetta from MY 2011
- Dual Clutch, Removing:
- through Transmission Production Date 05/2011. Refer to ⇒ 1 Dual Clutch, Removing and Installing, through Transmission Production Date 05/2011
- from Transmission Production Date 06/2011. Refer to ⇒ 2 Dual Clutch, Removing and Installing, from Transmission Production Date 06/2011.

- Remove the outer seal.

- Drive in the outer, »new« seal flush to the clutch housing using a plastic mallet.
- The Press Piece - 60mm - VW415A- offset points upward -arrow-.
- Remove the Puller - Shaft Seal - T10420- spindle.

- Install the Puller - Shaft Seal - T10420- on the »small«, inner seal. Press on the Puller - Shaft Seal when doing so.
The Puller - Shaft Seal will jam the seal when it is being turned It can be »felt« when the seal begins to move in its place.

- Now install the spindle.
- Remove the seal using the spindle.

- Drive in the »new« seal all the way.
- Dual Clutch, Installing:
- Through Transmission Production Date 05/2011. Refer to ⇒ 1.4 Dual Clutch, Installing, Transmission Production Date through 05/2011
- From Transmission Production Date 06/2011. Refer to ⇒ 2.4 Dual Clutch, Installing, Transmission Production Date from 06/2011.
- Install the transmission:
- Refer to
- Refer to ⇒ 5 Transmission, Removing and Installing, Jetta from MY 2011