7-speed DSG gearbox 0AM (DQ200) · Clutch · Dual Clutch, Removing and Installing, from Transmission Production Date 06/2011
Overview – Dual Clutch, Transmission Production Date from 06/2011
- 1 Engaging Lever Support
- For the large engaging lever “K 1”
- Is not replaced
- 2 Ball Stud
- For the small engaging lever “K 2”
- Always replace when replacing the dual clutch
- 3 Shim “SK 1”
- Selecting thickness. Refer to ⇒ 2.3 K 1 and K 2 Clutch Engaging Bearing Position, Adjusting, Transmission Production Date from 06/2011.
- 4 Shim “SK 2”
- Selecting thickness. Refer to ⇒ 2.3 K 1 and K 2 Clutch Engaging Bearing Position, Adjusting, Transmission Production Date from 06/2011.
- 5 Small Engaging Bearing for “K 2”
- Always replace when replacing the dual clutch
- 6 Dual Clutch
- Removing. Refer to ⇒ 2.2 Dual Clutch, Removing, Transmission Production Date from 06/2011.
- Installing. Refer to ⇒ 2.4 Dual Clutch, Installing, Transmission Production Date from 06/2011.
- 7 Circlip
- Always replace after removing
- 8 Hub
- 9 Circlip
- Always replace after removing
- 10 Large Engaging Lever for “K 1”
- With engaging bearing
- Always replace when replacing the dual clutch
- 11 Guide Sleeve Upper Section
- For the small engaging lever “K 2”
- Removed and installed together with the guide sleeve lower section
- 12 Small Engaging Lever for “K 2”
- Is removed and installed together with the guide sleeve upper section and lower section
- Refer to ⇒ 2.3 K 1 and K 2 Clutch Engaging Bearing Position, Adjusting, Transmission Production Date from 06/2011
- 13 Bolts
- 8 Nm +90°
- Always replace after removing
- 14 Guide Sleeve Lower Section
- For the small engaging lever “K 2”
- Removed and installed together with the guide sleeve upper section
- 15 Seal
- For the inner input shaft
- Replacing. Refer to ⇒ 3 Clutch-Side Seals, Removing and Installing.
- 16 Seal
- For the outer input shaft
- Replacing. Refer to ⇒ 3 Clutch-Side Seals, Removing and Installing.
