1.6 TDI CR engine (EA189) · Turbocharging/supercharging · Turbocharger
Turbocharger – assembly overview and fastening
⇒ 1.1.2 Assembly overview - turbocharger, Polo
1.1.2 Assembly overview - turbocharger, Polo
- 1 Turbocharger
- Only renew together with exhaust manifold
- Removing and installing ⇒ 1.2 Removing and installing turbocharger
- 2 Pressure canister
- With position sender for charge pressure positioner - G581-
- Renewing ⇒ 1.3 Renewing vacuum unit for turbocharger
- 3 Connector
- To position sender for charge pressure positioner - G581-
- 4 Heat protection
- Renew if damaged
- 5 Seal
- Renew
- 6 14 Nm
- 7 Connecting pipe
- To exhaust gas recirculation cooler
- 8 Exhaust gas temperature sender 1 - G 235-
- 45 Nm
- Removing and installing ⇒ 3.2 Removing and installing parts of exhaust gas temperature regulation
- 9 10 Nm
- 10 Bracket
- 11 Heat shield
- 12 10 Nm
- 13 Turbocharger support
- Removing and installing ⇒ 4.2 Removing and installing oil supply line
- Before installing oil supply line, ensure that it is not blocked.
- Before installing, fill turbocharger with engine oil through oil supply line connection.
- 14 O-ring
- Renew with banjo bolt.
- 15 Banjo bolt, 60 Nm
- Renew complete with O-rings.
- 16 Oil return pipe
- 17 Ribbed bolt
- Renew
- 14 Nm
- 18 Banjo bolt, 30 Nm
- Renew complete with oil seals.
- 19 Seal
- Renew
- 20 Oil supply line
- Removing and installing, Polo ⇒ 4.2 Removing and installing oil supply line.
- Before installing oil supply line, ensure that it is not blocked.
- 21 Pulsation damper
- 22 9 Nm
Installation position of O-ring and seals in pulsation damper
Installation position of exhaust gas temperature sender with angled cable guide
Tightening torques on this page
8 torques
1.1.2 Assembly overview - turbocharger, PoloTo the drawing ↑


