Brake systems · Brakes – hydraulics · Assembly overview – brake booster/brake master cylinder

Removing and installing brake light switch F, right-hand drive

Removing

  • Remove noise insulation ⇒ General body repairs, exterior; Rep. gr. 50; Front of body.
Removing and installing brake light switch F, right-hand drive: drawing 1
  • Undo bolt -arrow B- of brake light switch - F- -1- from brake master cylinder.
  • Pull brake light switch - F- -1- out of brake master cylinder upwards.
  • Pull brake light switch - F- -1- out of brake master cylinder locking lug -arrow A-.
  • Remove brake light switch - F- together with wiring.
  • Release connector of brake light switch - F- and pull it off.

Installing

Install in reverse order. Note the following points:

Removing and installing brake light switch F, right-hand drive: drawing 2
  • Insert brake light switch - F- -1- into brake master cylinder locking lug -arrow A-.
  • Screw in bolt -arrow B- and tighten.

Specified torque

ComponentSpecified torque
Brake light switch - F- to brake master cylinder7 Nm

Tightening torques on this page

1 torque

PartTorque
Brake light switch - F- to brake master cylinder7 Nm

All tightening torques in this manual →