SSP 308 Direct Shift Gearbox 02E

Gear selection

Gear selection (S308_047)

The gears are selected via selector forks in the same way as a manual gearbox. Two gears are selected by each selector fork.

Actuation of the selector forks is hydraulic on the direct shift gearbox and not by means of selector rods, as on conventional manual gearboxes.

The selector forks run on ball bearings in a cylinder.

Gear selection (S308_048)

To select a gear, oil is fed into the left cylinder by the mechatronics. Since the right cylinder is not under pressure, the selector fork is moved and actuates the locking collar. This results in gear engagement.

Once the gear is engaged, the selector fork is moved to a "no pressure" position. The gear is held in place by a chamfer on the selector teeth and by a locking mechanism on the selector fork.

When the selector fork is not actuated, it is held in place in the gear casing (gearbox) by a locking mechanism.

A permanent magnet is fitted to each selector fork. The permanent magnet allows the travel sensor in the mechatronics to detect the precise position of the selector forks.