7-speed DSG gearbox 0AM (DQ200) · Controls, Housing · DSG Transmission Mechatronic J743

Overview – Mechatronic

Overview – Mechatronic: drawing 1
  • 1 Bolt
    • 10 Nm
    • M8 x 35
    • Always replace after removing
  • 2 Bolt
    • 10 Nm
    • M8 x 90
    • Always replace after removing
  • 3 DSG Transmission Mechatronic - J743-
Overview – Mechatronic: drawing 2

Pay attention to the vent when handling the Mechatronic.

  • When doing assembly work on the Mechatronic, please remove the cap -arrow- from the vent and seal the vent with a suitable plug.

The Protective Cap - 0AM 325 120- is well suited for this.

Checking the hydraulic fluid level for the Mechatronic is not possible. The Mechatronic vent must be sealed oil-tight before performing any assembly work.

Fluid that has leaked out of the Mechatronic hydraulic area may not be refilled or checked. Replace the Mechatronic if fluid is leaking.

Tightening torques on this page

2 torques

To the drawing ↑

Drawing with the item numbers:

All items:Always replace after removing

ItemPartTorqueNotes
1Bolt10 NmM8 x 35
2Bolt10 NmM8 x 90

All tightening torques in this manual →