7-speed DSG gearbox 0AM (DQ200) · Controls, Housing · Transmission Fluid, Replacing

Transmission Fluid, Replacing

Special tools and workshop equipment required

  • Used Oil Collection and Extraction Unit - SMN372500-
  • Oil Filler - VAS6262A- with Adapter For Oil Filling - VAS6262/4-
Transmission Fluid, Replacing: drawing 1
  • It is necessary to use the Oil Filler - Adapter 6 - VAS6262/6- on some oil containers.
  • It may be necessary to shorten the bleed pipe on the Adapter For Oil Filling - VAS6262A-. Refer to ⇒ 1 Transmission Fluid, Replacing.
  • Container with the transmission fluid for the 7-speed DSG® transmission 0AM. Refer to the Parts Catalog for the part number.
Transmission Fluid, Replacing: drawing 2

Measuring the Length of the Bleed Pipe on the Adapter For Oil Filling - VAS6262A- and Shortening if Necessary.

The bleed pipe on the Adapter For Oil Filling - VAS6262A- must be shorted to dimension -a- so that it does not touch the bottom on some containers.

  • Dimension -a- = 210 mm

If dimension -a- is greater than 210 mm:

Transmission Fluid, Replacing: drawing 3
  • Make a mark on the bleed pipe, dimension -a-, and cut it, with for example the Brake Line Tool Kit - Pipe Cutter - VAS6056/2-.
  • Clean the Oil Filler - VAS6262A-.

Procedure

  • Raise the vehicle.
  • Remove the noise insulation. Refer to ⇒ Body Exterior; Rep. Gr. 50; Noise Insulation.
  • Place the Used Oil Collection and Extraction Unit - SMN372500- or Drip Tray under the transmission.
Transmission Fluid, Replacing: drawing 4
  • Remove the drain plug from the transmission.
  • Drain the fluid and then install the drain plug and tighten it.
Transmission Fluid, Replacing: drawing 5
  • Remove the battery and the battery tray -arrows-. Refer to ⇒ Electrical Equipment; Rep. Gr. 27; Battery; Battery, Removing and Installing.
Transmission Fluid, Replacing: drawing 6
  • Remove the bleed cap -arrow- next to the transmission gearshift lever.
  • Shake the container before opening.
Transmission Fluid, Replacing: drawing 7
  • Attach the transmission fluid container for the 7-speed DSG® transmission 0AM to the Adapter For Oil Filling - VAS6262A-. Refer to the Parts Catalog for the part number.
Transmission Fluid, Replacing: drawing 8
  • Hold the container so that no fluid can run into the filling hose.
Transmission Fluid, Replacing: drawing 9
  • Connect the Oil Filler - Adapter 4 - VAS6262/4- to the filling hose and mount it on the bleeder on the transmission.
  • Screw in the container and fill 1.7 liters (1.79 quarts) of transmission fluid.
Transmission Fluid, Replacing: drawing 10
  • Remove the Oil Filler - VAS6262A- after filling. Wipe the area around the bleed hole with a clean cloth and install the bleeder cap -arrow-.
  • Install the battery tray and the battery -arrows-. Refer to ⇒ Electrical Equipment; Rep. Gr. 27; Battery; Battery, Removing and Installing.
  • Install the noise insulation. Refer to ⇒ Body Exterior; Rep. Gr. 50; Noise Insulation.