7-speed DSG gearbox 0AM (DQ200) · Controls, Housing · DSG Transmission Mechatronic J743

DSG Transmission Mechatronic J743, Moving into »Removal Position« by Hand

Special tools and workshop equipment required

  • Pry Lever - 80-200-

Sometimes it may not be possible to remove the Mechatronic. In this case, the gear selector will get »caught« at the »top left side« on the transmission housing -arrow-.

DSG Transmission Mechatronic J743, Moving into »Removal Position« by Hand: drawing 1

The gear selector that is »caught« -arrow- can be pushed into a »removal position« by hand. Slide a shift fork behind the parking lock cover to do this. Do this according to the following procedure:

  • Place the Mechatronic back on the transmission housing and secure the Mechatronic with a screw.
  • Move the selector lever into “P”.
DSG Transmission Mechatronic J743, Moving into »Removal Position« by Hand: drawing 2
  • Remove the lock washer in the direction of the -arrow-.

Always replace the circlip on the selector lever cable.

DSG Transmission Mechatronic J743, Moving into »Removal Position« by Hand: drawing 3
DSG Transmission Mechatronic J743, Moving into »Removal Position« by Hand: drawing 4
  • Remove the selector lever cable from the ball head on the selector lever using, for example, a Pry Lever - 80-200-.
  • Push the selector lever all the way toward the cable bracket by hand.
DSG Transmission Mechatronic J743, Moving into »Removal Position« by Hand: drawing 5
  • Remove the selector lever.
  • Remove the cover.
DSG Transmission Mechatronic J743, Moving into »Removal Position« by Hand: drawing 6
  • Push the shift fork to the side through the opening in direction of -arrow-.

(Press in the direction of travel to the left).

The gear selector that is »caught« will also be pushed back and it will be possible to remove the Mechatronic.

DSG Transmission Mechatronic J743, Moving into »Removal Position« by Hand: drawing 7
  • After completing the work on the Mechatronic and it is installed, fill the transmission fluid via the parking lock.
DSG Transmission Mechatronic J743, Moving into »Removal Position« by Hand: drawing 8
  • Lubricate the seal in the parking lock cover with Sealing Grease - G 052 128 A1-.
DSG Transmission Mechatronic J743, Moving into »Removal Position« by Hand: drawing 9
  • Attach the cover and gearshift lever again.
DSG Transmission Mechatronic J743, Moving into »Removal Position« by Hand: drawing 10
  • Press the selector lever cable onto the ball head on the selector lever again and install the new lock washer.
  • Always replace the circlip on the selector lever cable.
  • Adjust the selector lever cable. Refer to.

Tightening torques on this page

1 torque

In the steps

StepTorque
Bolt tightening specification -arrows-: 8 Nm +90° additional turn.8 Nm +90°

All tightening torques in this manual →