7-speed DSG gearbox 0AM (DQ200) · Controls, Housing · Transmission, Transporting and Securing To Assembly Stand

Transmission, Transporting and Securing To Assembly Stand

Special tools and workshop equipment required

  • Holding Plate - VW309A-
  • Transmission Support - VW353-
  • Engine Sling - 2024A-
  • Lifting Eyebolt - 3368-
  • Engine and Gearbox Bracket - VAS6095A-
  • Shop Crane - VAS6100-
  • Engine/Gearbox Support Shackle (2 pc.) - 10-222A/12-
  • Engine Bung Set - VAS6122-
  • Protective Cap - 02M 409 120-, alternative for Engine Bung Set - VAS6122-
  • Protective Cap - 0AM 325 120 A-
Transmission, Transporting and Securing To Assembly Stand: drawing 1

Transmission, Transporting

Transmission, Transporting and Securing To Assembly Stand: drawing 2

Seal the Transmission So That No Fluid Can Leak Out.

The vent on the DSG Transmission Mechatronic - J743- (-rear arrow-) and the transmission ventilation (-left front arrow-) must be sealed tight so that no fluid can leak out during assembly work.

  • Fluid that has leaked out of the DSG Transmission Mechatronic - J743- hydraulic area may not be refilled or checked. Checking the hydraulic fluid level in the DSG Transmission Mechatronic - J743- is not possible.
  • If transmission fluid has leaked out, then it is necessary to perform a transmission fluid replacement. It is not possible to check the fluid level.
  • Underfilling or overfilling both fluid systems will impair the function of the transmission.
  • Remove both vent caps -arrows- and seal with clean oil-tight plugs from the Engine Bung Set - VAS6122-.
  • Seal the transmission ventilation and DSG Transmission Mechatronic - J743- vent using clean plugs from the Engine Bung Set - VAS6122-.
  • If necessary, order a new vent cap arrow for the DSG Transmission Mechatronic - J743-. It must be replaced after installing the transmission. Refer to the Parts Catalog.
  • The seals must be removed after installing the transmission and the vent caps must be reinstalled or replaced.
Transmission, Transporting and Securing To Assembly Stand: drawing 3

Secure the Transmission on the Transmission Support - VW353-.

Requirement:

Transmission, Transporting and Securing To Assembly Stand: drawing 4

Lift the Transmission into the Assembly Stand.

Requirement:

The transmission is lifted together with the Transmission Support - VW353- »into the assembly stand«.